stainless steel pressure solar water heater (CE,CCC,ISO) - SJL-TH

Stainless steel pressure solar water heater (CE,CCC,ISO)

Specifications:

Inner tank: Pressurized food grade SUS304/2B stainless steel with 0.50mm thickness

Outer tank: SUS304-2B stainless steel with optional 0.40mm thickness

Copper coil: TU1 red copper, diameter 12mm, thickness 0.80mm

Water capacity: 200L, 300L

Pressure: 0.6 MPA

Heat preservation: 80-90hours

Hail resistance: 28mm

Tube standards: 20, 30 borosilicate glass 3.3 tubes with 58mm diameter and 1800mm length.

Absorptive rate: more than 96% (AM1.5)

Stagnation temperature: 300 centigrade degree

Freezing resistance: -50 centigrade degree

Heat insulating layer: Improved polyurethane integral foaming with thickness 60mm

Bracket: Stainless steel SUS304/2B with optional 0.55mm thick

Fasteners: stainless steel screws

Seal: Imported silicone rubber polymer ring to connect and seal

Features:

1, Can be used at any time to warm the cold water, it can overcome the shortcoming of traditional solar water heater, such as slow heating rate, long waiting time.

2, High efficiency, a special heat exchanging mode is adopted to avoid mixed effect, so cold water can be heated at any moment.

3, Water pressure is same as tap water, it can be connected directly to city tap water system.

4, Green and economical, no pollution in working, no cost for hot water.

5, Easy operation, automatic water supply, you can take it easy and enjoy good time.

6, Fashionable, the appearance is nice and attractive and can fit into the surroundings properly.

Working principle:

The vacuum with water flow absorbs solar energy and transfer heat into the tank. But the water in the tank is not to use. The tank just as a storage tank, one copper coil is installed in the tank as the heat exchanger. When water flows in to the copper coli, it absorbs the heat of the water in the tank via copper coil.