pressurized and split hot water system - MAX-FTS

pressurized and split hot water system

Features:

1. Pipeline is made of all red copper and conducted by heat transfer medium liquid.

2. Water doesnt flow in the vacuum tubes, and if one of the tubes is broken, the water in the water tank would not leak out, the solar water heater can be used as usual.

3. Split design made the installation unlimited

Heat collector is separated from water tank, so it can be installed flexibly. The collector can be put on both tilted roof and flat roof. It is combined with construction ideally.

4. Tank is equipped with electric water heater device and automatic temperature controller.

5. Intelligent control and automatic operation.

6. The water tank is placed indoors and it is in favor of reducing the heat loss.

Specification:

1. Collector channel: copper pipe

2. Collector crust: aluminum alloy

3. Tube with 58mm*1800 length

4. Water capacity: 100 L; 150L;200L; 250L; 300L; 350L; 400L; 450L; 500L

5. Material of inner tank: SUS304-2B food grade stainless steel or porcelain enamel inner tank

6. Material of outer tank: galvanized steel

7. Pressure: 0.6 MPa

8. Hail resistance: 25mm dia.

Working Principle:

1.The high quality vacuum tube absorb the solar ultraviolet ray, conduct the heat to the water in the tank, then the water in the tank heat the water in the copper coil, we use the water in the copper coil, not the water in the tank.

2. When use hot water, open V1 the inlet tap water into copper coil.

3. It adopt the twice heat transfer and pressure-bearing technology, cease the pollution of the water source.