all in one heating pump house KYRS-410Y/150L

Specifications and Product Details:

all in one heating pump house with the following features:

1.pasonioc all in one heating pump
2.all in one heating pump house
3.cop:4.0 heating pump
4.refrigerant:R410a

5.safe,energy-saving,envirenment friendly

6.long service life: 15 years

all in one heating pump house Features:

1) Reliable compressor with R410a refrigerant.

2) Water exchanger equipped with Danfoss stainless steel Plate exchanger. (316)

3) Soft start control for single phase power supply models.

4) Water flow switch equipped for water flow protection.

5) Careful protection functions such as: high pressure, low pressure, overheating, overload ant freezing, phase order, discharge temp, etc.

6) Wilo water pump installed inside.

7) Flow switch for water flow protection.

8) Full sealed control box with water proof level IPX5.

9) Intelligent controller, and adjustment by quick mind microprocessor.

10) Air exchanger (fins- coil) with hydrophilic coating.

11) Stainless steel buffer tank included

all in one heating pump house operating principles

This heater is a successful application of reverse Carnot’s principle by a way that compressor takes in the low-temp and low-pressure gas as the freezing medium from the evaporator, then compresses the freezing medium into high-temp and high-pressure gas which goes into the condenser to finish its heat exchange with the to- be- heated water and then is condensed into cryogenic liquid by desorbing huge amount of heat, and the heat is finally absorbed by the water whose temperature can keep rising. The condensed high-pressure and low-temp liquid is then pumped down by expansion valve, and then through the fan in the evaporator, it volatilizes into low-pressure gas by taking in the heat from its surrounding air and eventually is absorbed into the compressor again. Thus hot water is generated through the above repeated recycling.

A simple stylized diagram of a heat pump's vapor-compression refrigeration cycle:

1) condenser, 2) expansion valve, 3) evaporator, 4) compressor.

all in one heating pump house Technical parameter:

Model No.	KYRS-4IY/200L
Water Volume(L)	150
Rated Output Water(L/h)	90
Type of Protection Against Electric Shock	I
Rated Heating Capacity(kW)	4.2
Rated Input Power(kW)	1.0
Rated Input Current(A)	5
Rated Temp.Of Water Output(°C)	55
Max.Temp.Of Water Output(°C)	60
Rated voltage/frequency(V/Hz)	220V~/50Hz
Compressor	scroll
Compressor Qty	1
Fan Qty	1
Noise( dB[A])	≤53
Working Temp.Range(C°)	-5~43
Dimension	570*1300H(mm)
Refrigerant Gas Type	R410a

Ry-bulb temperature:20°C, wet-bulb temperature:15°C, water inlet temperature:15°C and water outlet temperature:55°C.

Advantage:

1. Based on inverse cannot cycle principle, the unit can transfer energy in air into water through heat pump system, raise the water temperature to meet service conditions by consuming part of electric power.

2. It has high energy efficiency ratio, can produce 4kw heat by consuming every 1kw electric power. Comparing with traditional electric water heater which produces 0.95kw heat by consuming every 1kw electric power, its economic benefit is more than 4 times bigger than traditional heaters, or more than 2 times bigger than coal/oil (natural gas) furnace. Comparing with solar water heater, it is not restricted by installation conditions or weather conditions, can be used in all seasons.

3. Safely and reliable, electricity will not contact water directly during heating process, users will not suffer electric shock risk, nor explosion risk or poisoning risk of oil/gas furnace.

4. Environmental friendly, it will consume only part of electric power during operation, will not bring any pollution to the environment.

Application range:

It is mainly applied to houses, hotels, restaurants, schools, hospitals, swimming pools, bathhouses.

Pictures: