alcohol hand sanitizer dispenser - KP0858

Alcohol hand sanitizer dispenser &inductive hand disinfect& ionautomatic induction hand disinfection machine &automatic touchless sanitizer despensor&Wall Mounted Hand Sanitizer Dispensers&alcohol hand sanitizer dispensers& automatic hand disinfector

KP0858

Use 4 size '"D" batteres.

this model use partition-type sensor, Reaction is very sensitive and quick

The volume is 800 ml.

Just move your hand in front under the dispenser’s infrared sensor and a preset amount of liquid will spray to your hand.

It use liquid(medicinal alcohol)

spraying directly on your skin,Completing the disinfection within 30 seconds,Killing 99.6% of the surface bacteria on your skin,Restaining sustainably the bacteria within 6 hours after disinfection,There in no undesirable side effects,Volatilization is speed,There is no need washing and drying,The effect is good,the cost is low.

Installation method:

1. Fixed hole position in the installation position,thenn drill 3 hole with the diameter of 3-6MM, then fixed the hanging panel with the plastic plugs and screws attched with the machine.

2.Aline the fixed notch of the disinfector with the installed screws,then insert the screws from down to up.

Method of use:

1. Put 4 Size D dry batteries to the the battery box on the left side.

2.Open the machine, put disinfectant into it, closed the former shell.

3.Make the swich on,then put the hand within the sensor distance,the liquid will spray automatically.

This model use partition-type sensor, reaction is very sensitive and quick :Beside the nozzle;in the middle;below near the tray,which with the dark red colors,are all sensors.When you put your hand near ,or under the sensor,it can spray automatically.

4. This system software, a built-in correction for long-term stable job, when the battery runs out, will slow or does not reach the designated position, you need replace batteries.

5. When the red lights flashing for a long time, please replace the new battery.

6. The new battery replacement method: open the battery lid, hand battery replacement battery box, pull out a new battery, the battery using 1^rd.

7. Put the key on the cover lock, counter-clockwise, then lock body, vice verse can open it.

Technical parameters:

Voltage: 6V DC voltage

Capacity: 800ML

Induction distance: 3-15CM

Fluid volume: 2-3ML/time