USB Mobile phone Mini Hand-held air-conditioner fan Summer Mini Fan

Key Features

1)There are two ways of working air conditioning---Refrigeration&general fan mode

a)the random distribution with a full wet sponge after (as the standard of not dripping)

sponge back into the machine-specific area. Open air, cold air cooling can be achieved

b)If you do not want refrigeration,put the sponge out and continue to open the

air-conditioning,then there will be no cold wind will blow

Note:Sponge can be reused!

2)Power Supply

USB interface(There is a USB cable inside the package)

3)Notes

A)Product is not waterproof products, sponge should be removed with water after the

addition of water. Direct injection can not prevent water from entering the internal damage

to the machine

B)To fill the sponge is not dripping humidity prevail. If too much can be wrung out and then

flooding into the internal machine

C)Please note:Product is not resistant to high-altitude drops

D)It is recommend to dry the sponge after using the sponge,so as to avoid the breeding of

bacteria and odors.

Kind Tips: If you need it with the smell of the cold wind blowing out,you can put a few

drops of essential oil to the sponge on OK.Of course,we must remember that after use

the water soak into the dry cleaning again!

Installation of water sponge

1)Turn off the machine

2)by pushing the top lever pull to sponge off the lid with a sponge with water

3)for the first time: the water-cooled sponge soaked in tap water and rub thoroughly with

soap. Please be careful with sponges, do not wash too much pressure when.

4)If the sea water left there last used, please remove the sponge from the lid, the

remaining water squeezed out.

5)sponge in the water-cooled flat on the sponge to cover the same time as described

below: In the bottle filled with tap water, distilled water or mineral water, and even slow

down to 30ML of water throughout the sponge surface.

6)Insert the point of first jack, the sponge with sponge re-install the cover, then the

direction of the lid to lock into the host.

Note: Do not over-water sponge soaked. Do not brew the flow of water following a sponge. Master the use of 30ML of water immersion is difficult, you have been using bottles filled with water.

The machine is not waterproof, avoid contact with other water outside.

If water leakage occurs in the operation, then it may be your sponge into the water in excess (see Step Five); or perhaps you did not before soaking sponge the remaining water out of the previous.