Separated/Split pressure solar water heater system - SNP22

Split high pressure solar water heater system:

1. Material of manifold: imported SUS304-2B stainless steel aluminum alloy.

2. Vacuum tube: 47mm---1500mm, 58mm-----1800mm vacuum heat collecting tube, large amount of heat gaining.

3. High effect copper conduct heat-pipe, the heat efficiency no less than 95%,conduct heat fast, no water in vacuum tube, no water dirty, prevent frostbit.

4. Use automatic machinery foaming technique, super insulation capability.

5. Bracket: Elaborated designing ,high intensity plating aluminum and zinc steel board, treated by dry painting: stainless steel. Aluminum alloy.

6. Working pressure:0.6MPa

7. Reflect angle: 45

The principle of the system:

1. The collector applies the fourth generation of solar collector ----heat pipe vacuum collector to transfer the solar power to heat energy.

2.When the temperature of TC(the temperature of the collector) is higher than that of TR(the temperature of the water tank), the controlling device will start the circulation pump.

3.The circulation pump makes the working medium circulation in the system.

4. The heat is transferred from the heat collector to the water tank by the heat exchanger.

5. During the working process of the circulation pump, when the temperature difference is less than a set point, the circulating pump will stop.

6. When TR(the temperature of the water tank) reaches the highest of the set point ,the controlling device will close the circulation pump.

7.The electrical heating device will automatically make the temperature of the above part of water tank stay at the set point.

The characteristics:

1. The collector and the water tank are separated , and the system runs under the forced pressure.

2. The controlling device is specialized, so the system runs automatically.

3. The water tank can be installed anywhere.

4. the heat pipe vacuum tube collector is two circuit system ,free of freezing and could be used all year.

5. the metal super-conducting vacuum tube heat collector is used, no water in the tube, no bursting and could be used as usual under minus 50 .

6. the water tank applies with the enamel internal bladder ,runs under pressure.

7. provide the water at the same temperature ,set the highest temperature ,heat the water at set point by electricity, protecting the data when power off, supply the hot water 24 hours a day.

8. the system is designed separately ,in harmony with the structure.

9. The heat collector could be mounted on the balcony veranda ,the southern wall, sloping roof or awning.

10.The system is designed as unit, convenient to transport.