Sensor soap Dispenser - SY-002

Specification:

1.Item no.:SY-002

2.Product name: Soap Dispenser

3.Power:4pcs 1.5VAA Type Battery

4.Capability:400ML

5.Box Size:110x100x207mm

6.Ctn Size:515x474x435mm

7.Quantity/CTN:40pcs

8.20’GP:10600pcs

9.40’GP:21132pcs

10.40’HQ:25660pcs

11.Approval:CE&ROHS

Special drop quantum adjust switch:

1.We can adjust the drop quantum between 0.8ml to 3ml by the turn swith;

2.Dialed the turn swith to the left side, the drop quantum will be less and less;

Contrarily dialed on right side, the drop quantum will be more and more;

3.To close the power, please dialed the turn switch on right side unit hearedd the “tick” sound,

Contrarily to open the power.

Maintain and notice:

1.Choile a leve table to put the dispenser;

2.Do not install the dispenser above the mirror surface or above flowing water;

3.The senso is at the base of dispenser the effect range from 0-8cm underneath the sensor;

4.The product is design for indoor use only direct sunlight or exposed locations can dest or the infrared sensor of the product.;

5.Do not use the alcohol or other chemistry liquid;

6.This product doestn’t have waterproof function, please place product far from dampness.

If dispenser doesn’t work:

1.Check the battery whether the power use up or not at the right polarity.

2.Power switch not open.

If dispenser doesn’t drop:

1.You must operate dispenser several times when you first use it.

2.The liquid will congealed in winte, you need fill in some warm water(about 60°C),

After several minutes then operate it.

3.Perhaps no liquid.

Installation:

1.Open the cover;

2.Insert four pcs”AA” batteries to the battery compartment by correct direction;

3.Fill in the liquid to the container;

4.Turn the power on;

5.Put your hand under the sensor 0-8cm and let the dispenser to start working for continuously until liquid soap come out from nozzle.

(When you use dispenser at first time, there was some air in the pump, you need work dispenser several times until liquid scap drop down.)

Cleaning:

1. If there has dust in the container, please clean the container than refill in the liquid;

2.Do not use water to wash the dispenser, clean the surface use wet towel, use dry towel to clean the battery compartment;

3.If you no use, please fill in some water, then operate dispenser several times to cleaning the output pipe and take out the battery.

4.If liquid was congealed,fill in some warm water, wait few minutes, then operate dispenser and push out the water.