School&Office&Factory Reverse Osmosis Water purification - ZC-RO-100A

School&office&factory Reverse Osmosis Water purification

Favorable price
mineral and energy can be inputed
OEM/ODM service offered

Zunchuang provides "high-quality products with reasonable price".

Quality assurance for both during production and after-sale service

Specification:

Capacity: 100/200/300/400GPD

Flush type: auto-flush

Power supply: 220/110V AC at 50/60Hz

RO Membrane: CSM or FCS

Pump: diaphragm booster pump with adapter

Fitting type: JACO

Pressure tank: 100G

Product size: 400x 240 x 800mm

Pack Carton size: 415x 270 x 870mm

5 stages RO water purifier

1st Stage

The systems begins with normally a 1 to 5 micron sediment filters to hold back any large particulates including

large iron slits, dust, turbidity. This will prevent any deposition of large particles onto the ultra fine RO

membranes which typically in the order of 1 to 100 angstrom (1 angstrom = 1/10,000 micron or

1/10,000,000,000 meter of 1/10trillionth meter, this compare to human hair thickness with average diameter of

approximately 750,000 angstrom or 75 micron).

2nd stage

The Granular Carbon filter is then use to pick up about 90 to 95% of all the organic particles and remove the

majority of chlorine in the water stream. Under proper maintenance, the carbon filter will help to maintain the

efficiency of RO system for longer service life.

3rd stage

The Block Carbon filter is then use to pick up about 90 to 95% of all the organic particles and remove the

majority of chlorine in the water stream. The carbon filter can completely remove bad smell in water. Under

proper maintenance, the carbon filter will help to maintain the efficiency of RO system for longer service life.

4th stage

Then the fourth step is the use of RO which is the heart of the system. The fine membrane as explain by previous

article regarding the Reverse Osmosis. It acts as surface filter with fine enough mesh to pass only a small

amount of minerals and water molecules. Any long chain organic compound, including micro-organisms and also

artificial compounds such as pesticide and weedicide will be screen out. Because of the ultra fine mesh size of

the membrane, it will also block all harmful virus and other micro-organisms which may pass through in case of

alternative filtration technology.

Tank for Storage

For the high pressure drop of the Reverse Osmosis process in order to filter the water particles, the

clean water stream has very slow flow rate and a temporary water reservoir tank is used to buffer the flow when

no clean water is draw from the system. The clean water is collected in the tank when the system is in idea status

and also the tank will act as a pressure buffer to smooth out any pressure changes between the two side of

reverse osmosis membrane which will extend its life. A automatic shut off valve (whether it is a electronic or

mechanical) is then used to shut off water supply to the RO system when the water tank is full.

5th stage

There are sometimes small odors in the clean water which is a result of the interior finishing of the water tank

and inner lining of the tubing. Thus a final post carbon filter is normally added as a final polish filter to remove

such odors or taste and to give the great taste typical of spring water.

It is common for the sediment and the first carbon pre-filter to plug up and efficiency reduced by the end of

service life cycle and the second carbon filter has thus little effect to the overall performance of the system.

While adding a second activated carbon pre-filter to the system has no ill effect to the drinking water quality, the

use of such system may be subject to the water source conditions including chlorine concentration, organic

content (such as the case of having a no-pretreat surface water source), etc. and thus it is best to take to your

Perfect Life Water specialy agent for recommendation.

Quality guarantee and QC

We provide 1 year warranty of product and shipment with 1% spare parts.

QC team with more than 6 professional and technical personnel. To ensure 100% products checking.

Material: , meet international requested standards.

Semi-finished products inspection: Product inspection before 100% finished. Such as Visual Inspection, Leakage Testing, Safety Testing Etc...

Production line test: With work team or data engineer who will inspect machines and lines at fixed period.

Final Inspection: Quality and property test before packed and loaded.

change filter cartridge easily

PCB board:microprocessor control

water source:tap water final:pure water