New Pressurized solar water heater - JX solar water heater

Pressurized solar water heater
Features:
1. It adopts the Automatic argon welding solitary, and the lifespan is especially long.
2. For the all closed separated tank, the rated pressure is 0.6Mpa.
3. It adopts the super thick insulation layer, because it can keep warm and save electric energy.
4. It adopts the one-way anti-over pressure device, if the pressure is more than 0.6Mpa, the relief valve can reduce pressure and overflow automatically, so that the dirt in the tank can be drained easily.
5. Temperature pressure relief valve can protect overpressure.
When the leakage of the electric current is more than 10mA, it could cut off the electrical source automatically in order to keep safe.
6. There is the anode magnesium bar inside the tank to extend the lifespan.
7. The separated tank is especially suitable for water use of houses, hospitals, and the hotels.

Description

(1)The place of installing the solar water heater must be closed to the place of using, the temperature / pressure relief valve, temperature controller and electric heat pipe must be faced the direction where is easy to maintain. The data plate should be easy to read, and the space above the tank
should be over the height of the tank so as to check and change the positive pole protection device.

(2)The space around the tank should be convenient when pulling down the whole tank to maintain or change the parts in case of necessity.

(3)The tank is with vertical type; it must be installed in the level that can bear the weight of the product.

(4)Power socket must be installed in the position that the water can’t spray, so as not to produce vapor when taking a shower, then induce the socket leak electricity.The connection of cold water pipe:
The cold-water outlet is closed to the bottom of the power covering, and the interface is G1/2”. First connect the one-way safe drainage valve with the water heater, then join the close valve and connect with tap water pipe.
Note: When the pressure in the tank reaches some value, the one-way safe drainage valve can unload the pressure to tap water pipe automatically. So when you electrify to the tank, please keep the cold close valve open.

Usage

(1). Water supply:
First, open the close valve of the outlet of the tank and one hot faucet, and keep the water pipeline open. When the hot faucet works normally, which means water is full and then you could close the faucet.

(2). Settlement of hot water temperature:
The temperature regulation range of the temperature controller of the tank is 30~75°C, and the set temperature at 65°C before dispatched from the factory.
Warning: please pay attention to the scalding dangerous of the hot water, especially for the children and elders.

(3). Inserting the plug:
There must be good earth and three feet when you use the plug, and make the socket and power dry. The electric current that the outlet and wire allow passing is more than the one of the nominal current of the water heater.

(4). Close the water heater:
Close the power first, and then close the hot water globe valve of the water heater.

Specifications