Heat Pipe Pressurized Solar Water Heater With Copper Coil Inside Tank - LQ-ISWH-A1013

Changzhou Longquan Solar Since 1991

Heat pipe solar water heater details of material:

1 Inner tank: Stainless steel -0.50mm.

2 Vaccuum tube: 47-1500/58-1800.

3 Outer tank: Painted steel -0.5mm; Stainless steel SUS304-0.5 mm

4 Frame: Coated galvanized steel-1.2mm; Stainless steel SUS301_1.2mm.

5 The material of insuation: Polyurethane 55mm.

6 The reflector: Aluminum component: AL99.85% surface oxidation.

7 Copper coil: Φ 12mm, thickness 0.8mm.

The characteristic:

Use the copper coil as the heat exchanger, according with international fashion trend, it is simple to install and use.

It takes the advantage of the tap water's pressure. More pressure, more comfortable.

It can produce hot water with constant temperature, It is safe and comfortable to use.

The water can be heater rapidly, So it can produce the high quality hotwater.

It can produce more hot water than the general types because it isn't trestricted by the volume of the tank

1.High Efficiency, Rapid warming.The copper pipe in the heat pipe could transfer the energy into the cold water in the pressurized water tank rapidly.

2.The whole pressure of the system is up to 1.5kg/M2,the inner hole could connect the top water directly, work under the high pressure automatically.

3.The pressurized water tank and copper pipe in the heat pipe adopt the mechanical Seal advanced technology. Sometimes, although some of heat pipe are broken. The whole system still could go through very well.

4.The design for inner tank is reasonal and scientific, which could held 100,000 times fatigue test without any damage.

5.we take advantage of integrated foaming polyurethane technology.After foaming, inner tank ,Cover of outer tank, and out tank compose an integral whole. Which perfect insulation layer's benefit.

6.The system could adapt series and parallel connection to supply hot water for collective organizations

The water in water tank is only used for heat absorption,heat storage and heat release ,the water quantity in heat storage tank is constant ,the used hot water is produced in the follow procedure:the cold water enters in hear storage tank through winding pipe,the cold water absorbs the energy from solar hot water in heat storage tank and then turns hot ,as the built in properties of winding pipe, the temperature of output water is close to the temperature of solar hot water in water tank.

(Temperature difference<-3degree,this the compressive tap water compressive tap water continues entering winding pipe and absorbs the energy of solar hot water and then the tap water become hot and released for use.The water quantity in heat storage tank is constant,but the water temperature keeps dropping until temperature of the water in winding pipe has no heat transform value.)

Advantages:

1 solve the problem of non-pressure solar water heater’s zero pressure hot output.

2 solve the problem of inconstant water thermoregulation caused by maladjustment of nature fall pressure of non-pressure solar water heater and cold water pressure change of tap water.

3 The water capacity in water tank keeps constant in use in order to avoid the empty heating while the heat storage tank falling fetching water.

4 The heat storage water tank seldom feed water to avoid repeat operating complicated water feed problems every day.

5 The internal copper coil is 50m,and the life span could be above 50 years.