Alarm Panel With Remote Arm/Disarm by SMS - G12E

Home alarm system & wireless home alarm panel protect and monitor house, supermarket, office, villa, factory, farm and so on.

Specifications

1. Instruction

The alarm system adopts SMS data transmission and voice platform of GSM network to send control command and receive alarm remotely. The system can be set delayed-arm. When a signal is detected by detectors, the detectors will send alarm signal to host immediately, then the host sends alarm SMS to its pre-set mobile phone numbers, and meanwhile dials its pre-set telephone/mobile phone numbers automatically and drive wiretap. In addition, users can dial the system and set it in arm/disarm mode by any remote phones.

Following are the specific functions:

1.GSM alarm transmission, without connecting telephone lines and be not afraid of

cutting line.

2.The host automatically stores system status, while its power is off.

3. The system equips backup rechargeable battery .It can work while the external power

is off.

4.When a signal is detected by detectors, the detectors will send alarm signal to host immediately, then the host sends alarm SMS to its pre-set phone numbers, and meanwhile dials its pre-set mobile phone numbers automatically and drive wiretap.

5.Remote arm/disarm, and set the host by telephone

6.You can increase/decrease detectors

7.Support remote arm/disarm by telephone

8.Can connect with the alarm center through GSM network..

Specification:

Work voltage: 9V-12VDC Idle Power Consumption: 0.6W

a) GSM network frequency: 850/1900MHZ for G10EA , 900/1800MHZ for G10E

b) External power failure alarm

Start-time: less than 1s

c) Alarm response time

Less than 10s (GSM in normality)

d) Power requirements: AC 220V 50Hz

Standby battery: DC8.4V

Standby battery working hours: more than 10 hours

e) Working conditions

Operating temperature: -20 to 60°C

Humidity: 20% to 95%

f) Working frequency of detectors

315M & 433M (optional)